Quote:
Originally Posted by dubie
What's the track width on that crown Vic front end?
|
62" I believe. I plan on running some high offset wheels designed for a ford mustang up from and some 0 or very low offset wheels in the rear because the 8.8 came out of an explorer and is only 58.5" if I remember correctly. The stock steel Crown vic wheels fit inside the fenders as is, the high offset mustang wheels should fit nicely.
The only tough part was situating the mounting holes on the frame. On the bottom of the driver's side, they are just round holes. This put the holes for the sleeves very tight to the outer edge of the frame. The passenger side had all elongated holes so I was able to center the sleeves in the frame.