[dec010974]

Well, I would say yes & no. It's depends where the drive train will sit. I have no experience but there is a vendor that sells slider mounts. To ensure that no mods will be needed to your driveshaft, the 4l60e & driveshaft must sit in the exact location as the 700r4 & drive shaft. Once the 4l60e, driveshaft are in place, your lm7(5.3) can be mounted to the tranny using the slider engine mounts. My preference is to sit the engine in the engine bay first, see where it sits in relation to the radiator. Then you must decide if your gonna use electric fans or the current clutch fan clutch fans needs more space than electric fans. A drive shaft is a minor detail. I like my engines to sit forward, with space in the back to get to the oil pressure sending unit, camshaft sensor, grounds, or anything else that may need my attention. Again this is my preference. I hope this helps. Clark.