|
Re: wiring Pertronix Igniter III
Correct. on stock truck coil + is feed from the resistor during run, from the ing switch during start (one wire, the ing. is spliced into the wire from the resistor to give full voltage at start). I know nothing about Pertronix but the output to the coil should go to +. Coil - goes to the distributor points on stock.
__________________
1959 Chevy Short Fleetside w/ 74 4WD drive train (current project) OrrieG Build Thread
1964 Chevelle Malibu w/ 355-350TH (daily driver)
Helpful AD and TF Manual Site Old Car Manual Project
|