The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

Angryman117 · 02-08-2015, 11:28 PM

The engine harness I did myself and used info and pin-outs from LT1SWAP. The gauge cluster is actually from an 91 GMC, only have to re-pin 3 wires and add one for the TAC. The tac is fed from directly from the ECU (had to change the output settings in the ECU to make it read correctly). Motor mounts I build cause at the time I did not have time to wait for mounts to come in the mail, however at some point I will put the Dirty Dingo mounts in.

Young, what transmission are you going to run? I don't have a lot of pictures because I was on a tight schedule when doing the swap. What specific information are you looking for? If you have any more questions please let me know.

02-08-2015, 11:28 PM	#5
Angryman117 Registered User Join Date: Jul 2013 Location: VAFB, CA Posts: 227	Re: 89 Silverado Z71 The engine harness I did myself and used info and pin-outs from LT1SWAP. The gauge cluster is actually from an 91 GMC, only have to re-pin 3 wires and add one for the TAC. The tac is fed from directly from the ECU (had to change the output settings in the ECU to make it read correctly). Motor mounts I build cause at the time I did not have time to wait for mounts to come in the mail, however at some point I will put the Dirty Dingo mounts in. Young, what transmission are you going to run? I don't have a lot of pictures because I was on a tight schedule when doing the swap. What specific information are you looking for? If you have any more questions please let me know. __________________ Angryman117's 47 Chevy Build 89 Silverado Z71 LS Swap (sold)