View Single Post
Old 02-14-2015, 05:33 PM   #8
Nochance
Registered User
 
Join Date: Sep 2014
Location: Houston, Texas
Posts: 27
Re: Camaro rear disc brake conversion

Think about how this system is plumbed. You have 1 steel brake line running from the front to the rear crossmember where it ties into a rubber hose that splits it for each side. So if you have pressure on one side you have to have pressure on the other side too, unless you have a restriction in the lines after the split or you just have air in the system. I would try and bleed the system again first and make sure you're only bleeding one wheel at a time or you will get the same result you are getting now. Pump up pedel open one bleeder and close, pump up pedal and open another bleeder, and repeat until pedal is firm.
Nochance is offline   Reply With Quote