The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

Wrenchbender Ret · 03-06-2015, 11:08 PM

The shaft is located by a short dowel in one of the pockets the shaft sets in. There is a corresponding hole in the shaft that the dowel goes in to, to position the shaft. It looks about right but I don't have a truck like that at this time to compare it to. How does it look compared to the other side.

03-06-2015, 11:08 PM	#2
Wrenchbender Ret Registered User Join Date: Oct 2005 Location: Overland Park, Ks. Posts: 5,229	Re: Lower a arm position The shaft is located by a short dowel in one of the pockets the shaft sets in. There is a corresponding hole in the shaft that the dowel goes in to, to position the shaft. It looks about right but I don't have a truck like that at this time to compare it to. How does it look compared to the other side.