View Single Post
Old 03-10-2015, 01:58 AM   #7
kda2000
Registered User
 
kda2000's Avatar
 
Join Date: Oct 2013
Location: Austin, TX
Posts: 170
Re: WTB 67 clean stepside box fenders

I have a set -- with the spare tire cutout on the drivers fender. I bought the whole short bed for the bedsides but wasn't sure which fenders I was going to use, the original 68's or these. I had them media blasted and then I shot them with metal etch primer. First two pictures are when they came back from the blaster, the second two are with the primer on.

There are a couple pinhole rust spots in the bottom edge and there was a little bondo on the passenger side fender, where there was a small crease and some damage that was hammered out, but seems to be a decent job. If you look close at the last picture you can see it. Also you can see the worse rust spot if you look at the far right corner through the wheel well. (light through the hole).

I have lots of pictures that show all the surfaces inside and out, I can send them to you if your interested, PM me an email address. $130 + shipping for the set. I will work with you to get them packaged for shipping or on a pallet(s), would like them to find a good home. --- Ken
Attached Images
    
kda2000 is offline   Reply With Quote