View Single Post
Old 04-21-2015, 09:50 PM   #3
tiddlar
Registered User
 
Join Date: May 2014
Location: Tucson, AZ
Posts: 517
Re: Moser m9 purchase

Quote:
Originally Posted by Marv D View Post
for a 9" the bearing retainers will hold axles in place. A 35spline axle should slip into a piece of 1-1/2" roll bar tubing if you were worried about the weight on the axle bearings with nothing to align them. With no centersection you will be able to reach right in and slip the tube over both axles. (just put it on one when you install the axle)
No idea what you said.. Sent it to my fabricator see what he says. Sounds like it could work.. I'm not very mechanically inclined... That's a talent... I just didn't budget myself for the center section.. Though axle and housing would get me a roller. Hey thank you for your input
tiddlar is offline   Reply With Quote