The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

jorgensensc · 02-07-2004, 10:10 PM

Thanks for the replies, Mudder67,if you get a chance to look, I would appreciate it. I only need the float. I tried to find the hole in the float, but I can't get any air bubbles when I submerse it in water. I thought bout drilling a small hole, drainig it then using JB weld, but I'm concerned it might make the float heavier, and I don't know how well jb weld holds up to being submerged in gasoline.

02-07-2004, 10:10 PM	#7
jorgensensc Registered User Join Date: Jul 2003 Location: Cypress, Tx Posts: 4,005	Thanks for the replies, Mudder67,if you get a chance to look, I would appreciate it. I only need the float. I tried to find the hole in the float, but I can't get any air bubbles when I submerse it in water. I thought bout drilling a small hole, drainig it then using JB weld, but I'm concerned it might make the float heavier, and I don't know how well jb weld holds up to being submerged in gasoline. __________________ 1972 C20 Suburban- Big Blue Betty '56 Chevy Bel Air Sedan- Frame up Restoration -What would you attempt to achieve if you knew you could not fail?- -I Refuse To Tiptoe Through Life, Only To Arrive Safely At Death's Door- R.I.P. EAST SIDE LOW LIFE