Thanks Brian, dont think i noticed any but should be doing that today.
I got the th400 yoke off of the DS earlier and cleaned it up some. Slid it onto the 4l80e shaft to notice the seal is too big and wont.....seal. lol
Bolted the coil packs back on (will paint the VCs later) and started on cleaning the accessory bracket by removing the ALT until I saw the PS pulley and it's need to remove that before you can get the bolts off -____- so hopefully I'll get that part done too.
Was going to plug the harness up until I noticed I never finished taping up over the wire loom....and guess what?...had no tape. lol so that's 3 fails so far
