The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

dwcsr · 05-10-2015, 10:44 PM

You have an 4 degree difference and as said 4 up on the rear. As for measuring length use what ever method the maker of your shaft recommends, Most are rear yoke where the caps bolt on to the trans housing seal. they will also need the stick out of the tail shaft and spline count. Also the trans type and if its a slip yoke or a bolt on yoke. If your going to use a slip and it was a bolt on they need to know that as well.

05-10-2015, 10:44 PM	#3
dwcsr Hollister Road Co. Join Date: Apr 2005 Location: Houston Posts: 6,131	Re: Need help with pinion angle You have an 4 degree difference and as said 4 up on the rear. As for measuring length use what ever method the maker of your shaft recommends, Most are rear yoke where the caps bolt on to the trans housing seal. they will also need the stick out of the tail shaft and spline count. Also the trans type and if its a slip yoke or a bolt on yoke. If your going to use a slip and it was a bolt on they need to know that as well.