|
Re: 61 ho 32 to 64 12 bolt ?
Okay here's what I came up with. These measurements are not ultra precise, but are fairly close. With the truck 12 bolt, the center of the axle tube to the center of the U-joint on the pinion yoke measures 11-5/8". The Eaton HO32 measures 12-1/4" from the center of the axle tube to the center of the U-joint on the pinion yoke. So the driveshaft will technically be 5/8" too short if you swap in a truck 12 bolt, but with that small amount it may be fine. It just depends on your particular driveshaft and trans.
|