Quote:
Originally Posted by Average Joe
Nice work! Door panels look great.
|
Thanks, haven't been doing much to it lately found the motor spun a bearing, so its been sitting in the yard. Last sat my dad and I started reassymbling the motor that came out of this originally (the one we thought spun a bearing but was blown head gaskets causing compression to go into other cylinders). So since we tore it apart to check everything we decided to order new bearings, rings, can, lifter, oil pump and gaskets. We got the crank, pistons, can and timing chain installed. This weekend we will get some more done.
No pics
but while the burb has been sitting I ran the power and video cable for the back up camera through the pass a-pillar across the roof down the d-pillar and out the rear quarter hole for wiring to the camera installed on the license plate. And instead of hooking it all up to work when I'm in reverse I hooked it up to a toggle switch so I can choose when I want to use it.
Installed blue LEDs in the gauge cluster, mounted a power distribution block from a 90's Chevy on the pass fender to remove all of the wires that I have been adding to the battery, also mounted my voltage sensing relay for my dual battery setup I am planing. So when all said and done my main battery will have only 1 power wire on it running to the starter then my power wire running to the original fuse block and all my additional power wires will run off the secondary battery.