Quote:
Originally Posted by OrrieG
How does the door fit in the cab opening? If it fits with a good gap I would be looking at the cab for compression front to back. With that bend, I would expect the rear gap to be wider and maybe even latching problems??? Old school fix involves door in closed position, come along applying tension to the passenger side at the bend, 4x4 and sledge hammer. With the right tension one good pop should move it back into place. Without the tension it will just bounce back. You will also need to tap the inside with a hammer to release the tension as it moves. I had to get a bend out of my tailgate using similar method.
|
I'll look again, but from memory, its not a wide gap. However that door does have a problem latching or opening the latch, you have to pop it just right.
I'll try taking the glass out, putting a spacer between the outer and inner door panels and putting some tension on it, see if I can pull them back in. I think I'll put a board across the whole door frame on the other side vs just hooking to the other door, don't want to wind up with two bent doors.
