Once Chad sent me the renderings, it was time to get started again. I contacted Speedway Motors and had them send me two of their 15 x 14 steel hoops
A little togetherness...
and a preview of what they may look like.. different offset of course
Again, thanks to the renderings Chad did, one major thing has changed. I was going to do the hubcaps in white with the copper striping, but I asked him to show me what they would look like chrome (even though it isn't original, it is close) and this did it for me...
This is where I am as of today. The hubcaps are out to be chromed and powder coated with the copper like the picture. The wheel centers are being welded into the hoops with the correct spacing so I will not have to narrow the rear axle or the frame rails.
And I am looking forward to a summer of long nights realizing the "VISION"
