|
Re: pasecetter FBody headers on 76 c10 (pics)
As long as they aren't dead ended into the frame a decent exhaust shop should be able to get them to work as is. If you start cutting/welding and disturb the coating it will pop off completely. I would try my hardest to built the exhaust to fit the headers. I usually build from the flange back. So I would bolt up a blank flange and get the pipe to clear then weld everything together. Angles as long as they are smooth don't hurt exhaust flow much. Cutting the end of the pipe on an angle and then putting in a slight bend will clear most obstacles.
__________________
Owner of North Point Car Care in Dundalk Md. We specialize in custom exhaust on both modern and classic vehicles. We are a full service auto shop from classics to modern vehicles. Feel free to contact me with questions. I will give a 10% discount to any board member.
|