|
Re: 308 rear end
Steve, you will need to set up the preload on the side carrier bearings and the pinion bearings. All that is required on the pinion is a new crush sleeve, but the side bearings use shims. If you are not replacing the bearings, you should be able to reuse the shims that were there. I would not advise reusing the crush sleeve though. Oh, and a new pinion nut or some loctite on the existing one.
__________________
70 C/10 SWB 402/TH400/3.73 "The Needy Beast"
200,000 Mile Club
Disc Brake Club
Owner installed options:
Front Sway Bar
Power Steering
Power Brakes
Cigar Lighter
Courtesy Lights
Deluxe Side Markers
Wiper Delay
Sliding Rear Window
Power Windows
Power Locks
Sniper EFI
2015 Silverado 1500 LS 4.3/6L80/3.23 lowered 2" front & rear
|