[stick72]

Thanks for the advice guys, its helping.

I got the plate off, and ran into the spacer. I tried to figure a way to leave it, or remove and reuse it. Both options failed and I ended up chiseling it off.

I'm getting closer to test fitting, although I'm a bit stuck with what to do at the back of the door. I have backed out the two bolts that secure the bedside, and the bedside will be replaced later. I expected to run the patch panel all the way to butt up against the new bedside, but there is something still attached in there. I don't really want to leave the last couple of inched of old metal there, just haven't figured out what is still in the way.

On a good note, although I will replace the torsion boxes later, they are provided a great deal of support. The drivers side isn't rusted through, and combined with the top still on its holding everything pretty solid as I mock up parts.