[Breadfather]

i haven't tried the c clamp thing as the pin does not move no matter what is going on with the valve, which is making wonder about the functionality of the valve.

I get plenty of fluid in the rear line to the valve. I cannot get it to come out of the back section of the valve. Even after I have just re installed the freshly centered valve. That is again making me think valve issue. I blew air through the rear line starting at the 9/16 line that runs from the valve, air went through no problem pushing old brake fluid with it, so I don't think the rear rubber line is the issue. I cannot get the nut that connect to the rear rubber line loose without ruining the line(already rounded the nut) so that is when I did the air test.

I adjusted the e brake cable after doing the brakes and it does work. Right now the wheel cylinders will not even move as a result of the lack of pressure in the lines.

I think I will be wasting my time trying to vacuum the fluid through the again freshly re entered valve starting from the drivers rear bleeder, but I figure I would try before spending the $70 on the new valve.