Quote:
Originally Posted by mjgord51
I have a radiator that I am trying to ID for the purpose of getting a fan shroud for the truck, it being the truck is a 68 C10 I6 3ott. V8 sbc/700R4 now. The radiator in it now ( 3 core ) is for a auto trans and it does look like it does belong to the fitment of the truck. Truck has a two electric fan setup that isn't mounted real good, has only 2 screws on the top for holding it to the core support. Below is a drawing of what I measured, all measurements are real close to what I have here. **IS THERE ANYBODY OUT THERE THAT CAN VERIFY IF THEY ARE RIGHT. Thanks, mjgord51
|
My passenger side top clip has been Gorilla glued on. Works fine but could use some cosmetics..
I had to cut 2 small areas for my hoses to fit by. Unnoticeable in truck. Has the same measurements as yours.
Yes...I use the clips at the bottom.