|
Re: 71 C10 SWB Project Built
Here is what I'm going to order to rebuild the rear end...all from SummitRacing.com
Eaton Posi 30 spline ETN-19556-010
Moser differential cover MSR-7111
Moser main cap stud kit MSR-7115
Moser axle bearings MSR-9559
Timken bearing and seal kit TMK-DRK322
Yukon axle shafts 30 spline YGA-21257
Yukon axle c clips YGA-33083
Yukon pinion shims YGA-55008
Motive Gear 3.73 ring and pinion 4 series MGR-GM12-373
Moser 1350 yoke MSR-PY100
Richmond carrier shims RMG-3800071
Tonight I cleaned up the rear end. (Soaked with oven degreaser, scraped off all of the grease and wire wheeled it) Put etching primer on it tonight and tomorrow I will be painting it with SEM Rust Shield. I have pictures but I will add them tomorrow.
|