Thread
:
1997 Silverado Stepside Project
View Single Post
10-09-2015, 12:27 PM
#
22
lsxponcho
Registered User
Join Date: Jul 2012
Location: Cheadle, Alberta
Posts: 78
Re: 1997 Silverado Stepside Project
The box made its way back on the truck! This was another all day thing, It was just too late to fire up the plasma cutter so I could trim the rear cross member of the box to fit down properly...There was interference with the new rear frame cross member/tank straps, so the box is sitting a couple inches back. Other than that it fits nicely with the notch (the entire center bed support has been removed). I also cut the bed hole for the fill spout. I ran the fuel line, and ran wiring up to the front of the truck for the pump/sending unit etc. I picked up a conversion u-joint for the nv3500 yoke yesterday too, so she won't need wood blocks for much longer.
lsxponcho
View Public Profile
Find More Posts by lsxponcho