The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

**special-K** · 10-15-2015, 10:58 PM

I always have mine made, but I see your situation. What I do is get two pipes bent with back to back 45s like a 'z' so the bottom is even with the other top (2 1/4" offset if 2 1/4" pipe) and weld bell flanges on. I'd have to measure how far back the bends are. These will pass over your crossmember and you can rotate to clear transfer case. I have mine made of 5' lengths but probably do 3-4 next time. I lightly clamp a muffler on and drive to muffler shop.
You don't have those, so maybe you could have someone make them and send them to you. 3' would do, so shipping wouldn't be bad. Sounds like you have plenty of time before needing them

10-15-2015, 10:58 PM	#2
special-K Special Order Join Date: Nov 2004 Location: Mt Airy, MD Posts: 85,851	Re: Exhaust kit for 4x4? I always have mine made, but I see your situation. What I do is get two pipes bent with back to back 45s like a 'z' so the bottom is even with the other top (2 1/4" offset if 2 1/4" pipe) and weld bell flanges on. I'd have to measure how far back the bends are. These will pass over your crossmember and you can rotate to clear transfer case. I have mine made of 5' lengths but probably do 3-4 next time. I lightly clamp a muffler on and drive to muffler shop. You don't have those, so maybe you could have someone make them and send them to you. 3' would do, so shipping wouldn't be bad. Sounds like you have plenty of time before needing them __________________ "BUILDING A BETTER WAY TO SERVE THE USA"......67/72......"The New Breed" GMC '67 C1500 Wideside Super Custom SWB: 327/M22/3.42 posi.........."The '67" (project) GMC '72 K2500 Wideside Sierra Custom Camper: 350/TH350/4.10 Power-Lok..."The '72" (rolling) Tim "Don't call me a redneck. I'm a rough cut country gentleman" R.I.P. ~ East Side Low Life ~ El Jay ~ 72BLUZ ~ Fasteddie69 ~ Ron586 ~ 67ChevyRedneck ~ Grumpy Old Man ~ Last edited by special-K; 10-18-2015 at 08:56 AM.