The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

**61ChevyPanel** · 10-19-2015, 09:49 PM

It was 20 years ago but I really don't think I had to make any changes to the driveshaft. To be honest, I don't know if I did check to see if the lengths of the two rears were different. I used a straight panhard bar at 33 5/8". Haven't had any rear end issues since the swap.

10-19-2015, 09:49 PM	#15
61ChevyPanel Active Member Join Date: Nov 2011 Location: Los Angeles, CA Posts: 113	Re: 61 ho 32 to 64 12 bolt ? It was 20 years ago but I really don't think I had to make any changes to the driveshaft. To be honest, I don't know if I did check to see if the lengths of the two rears were different. I used a straight panhard bar at 33 5/8". Haven't had any rear end issues since the swap.