|
Re: My 261 build and discussion thread!
I have a '62 261 in my '54 truck, you will enjoy the increased low end torque compared to the 235. I remember your earlier thread about your trans/rear end gearing charts, I was able to gear my rear higher (3.08) so I could keep up with Northern Cal freeway traffic. You have a good plan for rebuilding, more than I did, however you've probably found out how expensive it is to rebuild the old sixes. Even with less machine work than yours, compared to a sbc, I've spent twice as much for half the HP.
Keep in mind the '56 block is for the TF engine bay, when you replace the H20 pump you need the Jim Carter pump/pulley higher relocation kit to run the stock fan, otherwise if you use the '56 pump, the pulley is larger and lower. (I use an electric fan)
|