Quote:
Originally Posted by 87ChevyR10
That is the part number on my sticker.......
If you search the number in gmpartswiki.com it pulls up the number for the air breather for my truck.
|
thanks so that part number is the decal itself and not the entire assembly?
took some digging but I actually had saved a snap chat of the water pump install I hope this helps you and what you was looking for bud. Again the picture is a snap chat I had saved for whatever reason. My op is to just use high tach gasket adhesive on the COMPONET not on the engine block and that should keep the gaskets on while you place the pump in place then you will want to have a torque wrench ready and set to proper spec and torque in a cross pattern.
Author Gould rebuilt it and is well known in the ncrs world and has rebuilt another pump for me before also. i HIGHLY recommend him when you get it back it will be natural finish you will need to paint it back black and should be good to go. Again hope this helps it wouldn't let me upload it into a PM where you requested the pic.
