Well I am all married up. It was safe to say it was not a traditional wedding. Everything went good and it was a blast.
Anyway, I was able to get some work don this week on the truck. Had to fiddle with the door latch on the new door for a couple hours to get it ti fit right.
This is the door release button. I also had some clearance issues with the solenoid linkage binding up. Finally the keep it simple stupid approach worked best. Simple rod bent around the latch hole. I think I might need door poppers for the door to work. I could used some suggestions on where to mount them. I wanted to put them above the bottom hinge but I think the door has to close straight on the plunger. So the bottom left is where I think they need to go.