The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - U-Bolt Mod

ProudSoul · 11-19-2015, 03:12 PM

I was able to get the ones towards the cab side in but I couldn't get the ones towards the front in. I would like to know a good way to dimple the cross member as well. I have the other 2 sitting in the garage, at least one beefier one on each LCA is better that 2 skimpy ones

Also, when I did this I had trouble fitting the u bolts through the holes I drilled. I had to use a jack to bend the u bolts a little to get them through.

11-19-2015, 03:12 PM	#2
ProudSoul Registered User Join Date: Apr 2014 Location: Denison, Texas Posts: 63	Re: U-Bolt Mod - Lower Control Arm I was able to get the ones towards the cab side in but I couldn't get the ones towards the front in. I would like to know a good way to dimple the cross member as well. I have the other 2 sitting in the garage, at least one beefier one on each LCA is better that 2 skimpy ones Also, when I did this I had trouble fitting the u bolts through the holes I drilled. I had to use a jack to bend the u bolts a little to get them through.