PM'd you Jim on the chunk you need.
As for the repairs so far here is what I got done today.
I drilled out the spot welds on the wrapped edge and tried to drill out the spot welds on the seam from the inside of the panel but my drill is too tall and I wasnt able to. So I cut the warped section and left a lip at the seam, then got the chisel and popped the spots as I went.
Then I got the wire wheel going and then took some soapy water and a red scotch pad and started scrubbing out as much rust and grime as I could. Ill sand it down next and put Ospho on it to get the rust neutralized.
While I was at it I cut out the section that was rusted out above that area and took a scrap from a fender patch panel and used it to cut the plug. Still need to finesse it more and deal with the rust in that area before I tack it.
