Thanks for the replies. I read through a lot of posts last night and today. I'm not less then buggy eyed. lol
I've considered a lot of choices. To find a donor 73-78 truck and use that. Going to a 5x5 rotor. Then I would have to change the rear axle to match.
I don't think I need to go the donor route, especially that I would most likely get new rotors, calipers and hose. Then I thought I would just get the upper and lower arms, get aftermarket dropped spindles and go from there.
I think I would be able to use my 68 upper n lower arms if I use 73-78 spindles and change ball joints to match. Larger Tie rods and center link too.
Will different year ball joints fit in 68 arms??
Now I'm considering using my 68 arms and getting a kit. (
http://www.mcgaughystore.com/1960-19...-kit-mcgaughys ) and keep the 6 lug. I would use factory 15" steel rims. I would have liked to found late model 18" or 20" take offs to use , but found the center hub is too small.
Would spacers be a bad choice to use with late model wheels to be able to clear the hub?
Thanks again for steering me in the right direction to find what I need.