|
Re: 32 spline NP208 is not mating up to NV4500... what am I doing wrong??
Quote:
Originally Posted by kwmech
You shouldn't have to cut the shaft if the damper is removed. And change the input seal on the 208, looks like it has cracks in it
|
I'll have to look into removing the damper, I guess. I'm just really surprised to run into this after everything I read about the 208 and early 241 being a bolt-on part for the NV4500. This trans was behind a 350 in a 1 ton dually.
And good eye on the seal. It will be replaced along with several others after the parts are cleaned and painted.
|