02-07-2016, 04:18 PM
|
#60
|
Registered User
Join Date: Dec 2013
Location: Purmerend, Netherlands
Posts: 1,657
|
Re: Got it one piece at a time... 51 chev
Quote:
Originally Posted by LOW A D
I adjust the doors before i start welding in any patches.. As i weld in cab corners and the outer cowl patch, etc., I make the patches fit the door. Another little tip here, I always remove the door latch or striker before lining up the door because the latch can pull the door up or down unless it is perfectly aligned. After the door fits nice I set the striker and latch in the correct position. After new weather strip is installed you may need to make some minor adjustments but the door should stay pretty much in the same spot. Hope this helps
|
This sure helps, a lot!!
Thanks!!
I now know what to do
|
|
|