The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

**FL71C10** · 02-21-2016, 02:14 PM

I am looking at buying another truck. It's a 68 3/4 ton long bed, 2wd, 292, 4 speed, posi rear. No power brakes, no power steering. It is in decent shape, but has a rusted out hole in the bottom of the drivers door, and the passenger fender is rusted out at the bottom of the rear section (not too bad, but enough that I not would be happy leaving it). It runs and drives good, just needs a few tweaks like a throwout bearing, exhaust donut, and valve cover and oil pan gaskets. It's pretty far away from me, so I had someone go look at it for me.

Bottom line, it would be a decent running around truck, but needs a little bit more bodywork than I hoped. He wants $2500 for it, and it will cost me close to $1000 to get it home.

Ive attached some pics of the fender, door, sill plate area, and overall.

Any opinions would be welcomed.

02-21-2016, 02:14 PM	#1
FL71C10 Senior Member Join Date: Jun 2010 Location: Orlando, Florida Posts: 2,514	What do you think this truck is worth? I am looking at buying another truck. It's a 68 3/4 ton long bed, 2wd, 292, 4 speed, posi rear. No power brakes, no power steering. It is in decent shape, but has a rusted out hole in the bottom of the drivers door, and the passenger fender is rusted out at the bottom of the rear section (not too bad, but enough that I not would be happy leaving it). It runs and drives good, just needs a few tweaks like a throwout bearing, exhaust donut, and valve cover and oil pan gaskets. It's pretty far away from me, so I had someone go look at it for me. Bottom line, it would be a decent running around truck, but needs a little bit more bodywork than I hoped. He wants $2500 for it, and it will cost me close to $1000 to get it home. Ive attached some pics of the fender, door, sill plate area, and overall. Any opinions would be welcomed. Attached Images Last edited by FL71C10; 02-21-2016 at 02:28 PM.