View Single Post
Old 03-07-2016, 03:05 PM   #1
Crazy Rusty
Registered User
 
Crazy Rusty's Avatar
 
Join Date: Jul 2011
Location: Tacoma, WA
Posts: 176
Question rear frame crossmember/panhard attachment

I noticed while I started my frame prep that the frame crossmember that has the panhard bar connection point on it is about 1 1/2" offset from where it attaches side to side (shorter on the pass side I think) (red lines). While the rear measurements are exactly the same (blue lines)

This seems to be from the factory as while the frame is slightly out of square (1/4 - 1/2"), the crossmembers are all still factory riveted. Does anyone know why this was done? At first I thought the frame was way off or something was bent but measuring from rivet to rivet shows a definite change.
Attached Images
 
Crazy Rusty is offline   Reply With Quote