Thanks for the reply. That's not a bad idea using a large washer. Did your puller actually thread into joint? I think thats where I went wrong. The puller I used was one size to big so I didn't think it'd force itself in there, I got too distracted with getting the damn bearing off..stuff happens...
Did you attach the puller to the end of the bearing on? Mine didn't budge a bit, I just might have to use a torch like you suggested.
Quote:
Originally Posted by spookylynx
mine was a PITA too. I used a puller and did some minor damage to the threads too, however I was able to clean them up with a tap. Then I used a big thick washer to protect the threads and used the puller again and it worked. If yours is seized really bad you could use a small torch and try some heat as well.
|