[95chev-w/t-guy]

I have a flip kit in the back, currently cut coils in the front, about 3 (or more) coils cut out of the stock 1/2 ton springs (they were cut before I bought the truck, and the literally fall out with the front end of the truck on jacks). I got drop spindles and what I was told were lowering springs when I bought them, but I now believe they are stock springs. When I put the drop spindles in, I think they're 3", and the flip kit in the back I think is a 4-5" setup, I'm hoping the truck will more or less sit level given that it likely had a slight rake when it was stock. If it ends up dragging it's rear a little bit that's ok too.