Quote:
Originally Posted by VictoriaHardware
One other unique feature of the Suburban/Panel rear bumper is this cutout in the center along the bottom edge. It apparently was done to gain clearance for the spare tire. It's about 3/4" high by 10" wide. This was from a '66. I assume '60 - '66 were alike.
|
pretty sure both of my bumpers (64&65) have that...
"A crude measurement end-to-end shows 19 1/2" . Third pic is the right FRONT bumper bracket. They look similar, but the same measurement shows 22".
wonder if you could just use a front corner bracket, and cut 2 1/2 out and it would work?