[NastyBuzzard]

So I think I need an 85-91 4x4 crossmember, supposedly any will work and doesn't matter if 1500,3/4,1 ton... Just to mount it inside the frame. I also need to figure out if I will be using the 2pc driveshaft or not. I prefer not but I have to wait to get it all together to measure the length I will need. Otherwise I will need to trade down a front shaft of the 2 piece that will slide into the 208
tcase.

I didn't even step foot in the shop on Saturday or Sunday due to it being Easter weekend. It was kind of a nice break but I really missed it.

Also need to see about drilling holes in the firewall for the 80s hydraulic clutch master, as well as modifying the floor pan for the NV4500.