Quote:
Originally Posted by F.A.A.benny
ok now after reading your post again, I think I see what the issue is. I believe that you assume that if you remove the rivet and the pivot, that the rod will just slide right out. Well that is more than likely not going to happen. That rod goes through the slots of the flapper with pretty much a pressed fit, meaning its not just going to slide out.
|
Really? My heater box is out in the garage right now and I'm too lazy to go back out there. If you are correct, it sucks!
I'd really like to paint the inner side of my flapper, what do you suggest?