The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

FlounderGDI · 03-31-2016, 08:59 AM

I just picked up a van tilt for my 1969 CST-10... I already collapsed the intermediate shaft to push my non-tilt column forward a little last year. I'm reading that you have to move neutral safety switch. I'd like to not have to cut up the tilt column.

Is there a way to not have to move the neutral safety switch?

Also the column I got didn't come with the neutral safety switch it has the spot where one would go though. Can I use the one on my non-tilt truck column or do I have to buy a van neutral safety switch?

03-31-2016, 08:59 AM	#1
FlounderGDI Registered User Join Date: Sep 2009 Location: Lafayette, Indiana Posts: 339	Adding a Van Tilt I just picked up a van tilt for my 1969 CST-10... I already collapsed the intermediate shaft to push my non-tilt column forward a little last year. I'm reading that you have to move neutral safety switch. I'd like to not have to cut up the tilt column. Is there a way to not have to move the neutral safety switch? Also the column I got didn't come with the neutral safety switch it has the spot where one would go though. Can I use the one on my non-tilt truck column or do I have to buy a van neutral safety switch? __________________ 1969 CST/10 "GreenAndWhite" 1974 Nova (SOLD... End of an Era) 2000 Impala (RIP) 2008 Malibu Brand Loyal... I've never owned a Vehicle not made by Chevrolet.