The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

**mongocanfly** · 04-05-2016, 06:15 PM

If your going to use the return rail you don't need the vette filter reg..but you will want to put a good inline filter between pump and fuel rail. I used ss braid line with -an fitting all the way around. You can use steel line though.Your install may differ from mine so you'll need to figure out the parts you'll need, but the basics are you'll need a couple of pushlock fitting for the fuel rail (5/16& 3/8) to whatever line you use..and a couple more for the pump. Depending on the pump you'll be using..mine is a walbro 255 and uses -an fittings as well.

04-05-2016, 06:15 PM	#2
mongocanfly Post Whore Join Date: May 2015 Location: Alabama Posts: 14,694	Re: K10 swap questions If your going to use the return rail you don't need the vette filter reg..but you will want to put a good inline filter between pump and fuel rail. I used ss braid line with -an fitting all the way around. You can use steel line though.Your install may differ from mine so you'll need to figure out the parts you'll need, but the basics are you'll need a couple of pushlock fitting for the fuel rail (5/16& 3/8) to whatever line you use..and a couple more for the pump. Depending on the pump you'll be using..mine is a walbro 255 and uses -an fittings as well.