Quote:
Originally Posted by ilovesilver97
Can anyone recommend a new set of door locks and ignition switch for my 1972 Cheyenne Super?
I would like Nos or oem. Or is a new set better?
I would like same key.
My ignition switch sticks sometime and the doors don't lock too good right now.
|
PM sent
Quote:
Originally Posted by cleszkie
My experience:
1)Replace ignition switch with a used OEM Delco unit. The Chinese repops are not as good. You can simply remove the key tumbler from your current switch and install it into the replacement switch to keep the same key.
2) Remove, clean and lubricate your door locks. That will most likely bring them back to life. Also check to make sure your linkage isn't binding. That way, you can keep using your current key for the doors as well. BTW, only lubricate the locks with graphite powder. Liquid lubes will attract dust and dirt and cause the locks to gum up.
|
You are certainly right about the ignition switches as long as the used one has been tested.
I respectfully disagree about the graphite though. The main problem with graphite is that it attracts moisture, and after a few uses it builds up and becomes a sticky paste. I have disassembled a LOT of door and ignition lock cylinders and the ones that had graphite used in them were in much worse shape than any of them that were lubed with a spray lube. I know part of the problem is that people get really carried away with it though. It's the old adage that if a little is good a lot must be better.... If a spray lube with Teflon is used there is no oil to attract dust and dirt. Any lock will have a buildup of contaminants if they are not flushed once in a while with a good penetrating oil. I never recommend Graphite for any lock cylinder.
LockDoc