Quote:
Originally Posted by Toms67
Any chance you could grind The bushings to the proper height? You could do a little at a time until you get what you need.
Posted via Mobile Device
|
I've done this before. A lot depends on how much material you have at the flat part of the bushing to the hole for the bar. There is probably a lot there, just shave away a little on the flat section until you get the fit you want. Also, you want to leave the bushing a little tall so that it will be slightly compressed by the bracket to help hold it in place. Be sure to lube the inside of the bushing with the sticky snot grease that should have been supplied with your bushings. Do NOT use any kind of petroleum based grease.