The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

**FirstOwner69** · 05-14-2016, 08:51 PM

The original routing was in a fabric loom along the valley formed by the left valve cover and intake manifold. My original 350 left valve cover had a couple retainer clips for attachment. At the front, it dropped down to a clip retained by the bottom water pump bolt/stud then back and up to the temperature sensor.The pictures below show the routing. In the second picture the bolt/stud is in the wrong (top) hole.

EDIT: Added 3rd pic.

05-14-2016, 08:51 PM	#2
FirstOwner69 Registered User Join Date: May 2010 Location: Wisconsin & Arizona Posts: 4,854	Re: Temp gauge wire routing The original routing was in a fabric loom along the valley formed by the left valve cover and intake manifold. My original 350 left valve cover had a couple retainer clips for attachment. At the front, it dropped down to a clip retained by the bottom water pump bolt/stud then back and up to the temperature sensor.The pictures below show the routing. In the second picture the bolt/stud is in the wrong (top) hole. EDIT: Added 3rd pic. Attached Images Last edited by FirstOwner69; 05-14-2016 at 09:03 PM.