Hi all ,
After 10 months of daily use, I finally decided to get to work a little on my Chevy Truck.
1st step : removing of the bed floor.
It was relly not easy ton remove this "f...g" big sheet of 5mm steel. It weighs about 200 pounds !!!
I would like to drop a bit the rear suspension, so that the frame becomes horizontal.
What's the best way to do it ?
C'notch on the frame ? A little ? More ? Put the rear end from below to above the springs ? How many inches it will do? Or simply move the springs anchors a little more higher ?
Thanks for your help.
