View Single Post
Old 06-13-2016, 01:08 AM   #31
Praxiss454
Registered User
 
Praxiss454's Avatar
 
Join Date: Jun 2016
Location: Novato, CA
Posts: 519
Re: Newbie thinking about diving into a '65 GMC 1000

Quote:
The wiring plug hanging down is where the IGNITION switch (that is missing) belongs
That was my guess. Someone wired it w/ a push button that worked, but there was no "on" position as far as I could tell. If/when I buy the truck I'll be putting in a keyed ignition again.

Quote:
Engine numbers will be on the lower side of the Block near the starter.
Quote:
You need either the casting numbers on the rear drivers side of the block or the code stamped on the pad close to the distributor.
Speaking of engine components and locations -- is there a good exploded view diagram or microfiche that shows a '65 engine compartment, and in particular, a 230 ci engine?
Praxiss454 is offline   Reply With Quote