|
Re: Which of these is correct?
Quote:
Originally Posted by BugzC10
As stated, the originals were spot welded on....the angle goes on top of the wood. When I bought my truck I discovered the original angles had been cut off and replace with inverted angles so they could just lay a piece of plywood in the bed. I cut them out and replaced them with bolt-in angles from Mark-K in the correct orientation.
|
Do the bolts go through the side of the bed in areas you can see them, or does their kit only place bolts inside of where the fender is? I guess you could bolt the majority of it and use a couple good spot welds on each end?
|