The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - Another 2 piece driveshaft angle question

Koz1 · 07-31-2016, 06:57 PM

correction
all slopes are negative
2nd shaft angles towards rearend
pinion angle point's up so it's negative as well
using the spicer operating angle app
operating angle 1 is 1
operating angle 2 is 2.3
operating angle 3 is 3.5
do these angle's seem to be allright
btw- u-joints all tight,center carrier bearing no play,axle bearings,rearend,all ok.

07-31-2016, 06:57 PM	#2
Koz1 Registered User Join Date: Aug 2015 Location: USA Posts: 25	Re: Another 2 piece driveshaft angle question correction all slopes are negative 2nd shaft angles towards rearend pinion angle point's up so it's negative as well using the spicer operating angle app operating angle 1 is 1 operating angle 2 is 2.3 operating angle 3 is 3.5 do these angle's seem to be allright btw- u-joints all tight,center carrier bearing no play,axle bearings,rearend,all ok. Last edited by Koz1; 07-31-2016 at 07:04 PM.