The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - Has anyone used painless #60116 for speedometer

Big Port Jimmy 6 · 08-07-2016, 08:09 PM

Since this is in the LS section I am going to make an assumption that that is what you are working on. That 60116 is for an older trans to out put a speed signal. It screws on the Speedo cable out put on the trans and is a pass through and a signal generator. For the LS swapper it is exactly backwards.
You would need one like this. http://www.atrol.com/cablex.htm that wires in and uses the speed signal to drive a electric motor to turn the cable. Hope this helps Jay

08-07-2016, 08:09 PM	#2
Big Port Jimmy 6 Addicted to Rust Join Date: Dec 2009 Location: Abbeville SC Posts: 1,030	Re: Has anyone used painless #60116 for speedometer Since this is in the LS section I am going to make an assumption that that is what you are working on. That 60116 is for an older trans to out put a speed signal. It screws on the Speedo cable out put on the trans and is a pass through and a signal generator. For the LS swapper it is exactly backwards. You would need one like this. http://www.atrol.com/cablex.htm that wires in and uses the speed signal to drive a electric motor to turn the cable. Hope this helps Jay __________________ Current trucks: (48 GMC100 320 inliner) Gone (48 Suburban in pieces) Sold 87 GMC CCSB 5.3 4l60E Daily Driver ECTA National record holder XO/PP We never really grow up, we just learn how to act in public.