|
Re: lcm dash
I have the same dash, I had to trim some material from the corners of my plastic trim for it to fit into the insert, then the studs were too short behind like you mentioned.
I ended up turning the nuts that held the trim around, so the flat side is facing out. Looks odd and it barely grabs the studs, but it works. I figure there isn't a lot of pressure pulling on it so it should be fine.
Just wait until to try to install it! Thats where the real frustration begins. After a lot of in/out and trimming material I got it in. The worst fit is around the dash bezel, I ran a screw into the drivers side of the pad to get it to stay flat against the side.
|